- In Oblique cutting of metals , the cutting edge of the tool is inclined at an as angle less than 90° to the direction of the tool travel.
- In Oblique cutting system , the cutting edge of the tool may not clear the width of the workpiece (W/P).
- Frequently, more than one cutting edge are in motion.
- The chips flows on the tool face at an angle less than 90° with the normal on the cutting edge.
- In Oblique cutting system , the tool may or may not generate a surface parallel to the workpiece.
- In Oblique cutting system ,the maximum chip thickness doesn't occurs at the middle.
- In Oblique cutting system, is 3D in nature Fc,Ff,Fr.
- In Oblique cutting system force acts on large area hence changes of tool failure is low.
- In Oblique cutting system, the tool life is high.
Email subscription
Monday, April 27, 2020
Oblique cutting system (production process or manufacturing process)
Subscribe to:
Post Comments (Atom)
Comment jrur kre kaisa laga
ReplyDelete